Installation and Integration/ActionItems

Action Items for the Installation and Integration group

1. Cryostat design

TCO interface

• List of the components using the TCO
  • -> Where is the info?
  • -> Who?

• TCO dimensions

• Space inside needed to close the TCO

Roof penetration locations

• Detector support structure interference
• -> Jack

• Instrumentation feedthrus

• HV feed thru

• Detector readout feed thru

Cable routing to the feedthroughs

• -> Where is the info?
• -> Who?

Floor loading

The floor loading will probably be defined by the areal lift needed to reach the roof. A draft of the installation proceed needs revised and then the equipment at each step listed.

Main Steps are:

Installation of the detector support structure Installation of cryogenic piping, Detector installation.

I added info on the areal lift on the installation page.

• -> Where is the info?
• -> Who?

2. Underground space

Plan for the work flow

• -> Where is the info?
• -> Who?

Ross Cage Design

Bill's proposal: docdb entry

• -> Bill

Random information and questions

• If we make the cage tall enough to fit the APA crate inside, the excavation equipment for CF may not fit inside because the cage reduces maximum width by ~4” (100 mm) as compared to a slung load
• Making the cage taller also makes it heavier, reducing the weight capacity for both slung and cage loads
• Can we do to the Yates shaft for some items? Boundary conditions.